Use the CMD-4MR carbon monoxide detector for single sites when generator shutdown is NOT desired. 12 VDC operation. Features a state-of-the-art sensor that is unaffected by common cleaning solvents. Lowest current draw of any Fireboy-Xintex CO Detector. UL 2034 Listed for Marine use.
Product : XINTEX CARBON MONOXIDE DET 12V CO SENTINEL Manufacturer : FIREBOY-XINTEX Manufacturer Part No : CMD-4MR UPC : 619749000051
The CMD-4MR-RLY is the most advanced CO detector available from Fireboy-Xintex.
It features automatic generator shutdown capability.
When dangerous CO levels are detected, the CMD-4MR-RLY shuts down the generator, a common source of CO.
This detector also features multiple location warning, allowing up to six detectors to be linked in series. When one detector alarms, all connected detectors will alarm to alert boat inhabitants in other locations to the presence of CO. Features a state-of-the-art sensor that is unaffected by common cleaning solvents.
12 VDC operation
Low current draw
UL 2034 Listed for Marine use.
Product : XINTEX CARBON MONOXIDE DET 12V CO SENTINEL W/GENER SHUT DOWN Manufacturer : FIREBOY-XINTEX Manufacturer Part No : CMD-4MR-RLY UPC : 619749000068
The M-2A-R gas fume detector features include two-channel monitoring capability, plug-in sensors (second sensor optional), fault light alarm, fault lights to indicate a malfunction in either the module or one of the sensors.
A "press to test" button for each channel indicates either an OK or Danger condition.
An Alarm Silence button deactivates the alarm horn.
A microprocessor-controlled, two-channel gasoline fume detector in a low profile, water resistant design.
The system is calibrated to eliminate most nuisance alarms while allowing enough time to take action.
Product : XINTEX M-2A FUME DETECTOR Manufacturer : FIREBOY-XINTEX Manufacturer Part No : M-2A-R UPC : 619749211563
Single channel gasoline fume detector, with the same features as the M-1-R:
Alarm horn mute functions
Standard two-inch display unit with gasoline sensor and twenty feet of plug-together lead.
The MB-1-R adds a 10 amp relay to automatically start the bilge blower fan should gasoline fumes be detected. Installation requires only the addition of two wire leads from the control to the blower switch. To test, simply touch the test pad on the control: the red alert lamp will glow, the alarm horn will sound and the blower motor will start.
The system works with power requirements of up to ten amps at 12 VDC.
In addition to gas fumes, the MB-1-R can also detect high concentrations of battery hydrogen or engine exhaust
Indicator lamp automatically increases in brightness during daylight and softens at night
Product : XINTEX MB-1 FUME DETECTOR Manufacturer : FIREBOY-XINTEX Manufacturer Part No : MB-1-R UPC : 619749211594